Patriot 2WD L4-2.4L (2009)
12. Install the spring washer (2) and hub nut lock (7) over the hub nut and stub shaft. Install a NEW cotter pin (1) securing nut lock in place and wrap
the cotter pin prongs tightly around the nut lock.
13. Install the tire and wheel assembly (1) See: Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels - Installation.
Install and tighten the wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).
14. Lower the vehicle.
NOTE: If the original knuckle is being reinstalled, wheel alignment may not be necessary due to Net-Build design.
15. Perform wheel alignment as necessary. See: Alignment/Service and Repair/Wheel Alignment Procedures
