Patriot 2WD L4-2.4L (2009)
9. Tighten the brake pedal/booster mounting nuts in the proper sequence to 23 Nm (17 ft. lbs.).
10. Using Mopar(R) Lubriplate, or an equivalent, coat the surface of the brake pedal pin (3) where it contacts the brake booster input rod (1).
11. Install the power brake booster push rod (1) on the pin (3) mounted on the side of the brake pedal. Install a NEW retaining clip (2) on the end of
the pin. Do not reuse the old clip.
12. Install and adjust the stop lamp switch in the brake pedal bracket See: Lighting and Horns/Brake Light Switch/Service and Repair/Stop Lamp
Switch - Installation.
13. Install the steering column cover reinforcement (1) (if equipped) using the four mounting screws (2).
14. Install the steering column opening cover on the instrument panel.
