Patriot 2WD L4-2.4L (2009)
19. Install the left front brake tube into the clip located on the left body rail.
20. Install the master cylinder See: Brakes and Traction Control/Hydraulic System/Brake Master Cylinder/Service and Repair/Removal and
Replacement/Brake Master Cylinder - Installation.
21. Verify that brake master cylinder reservoir (1) is full. Top off with DOT 3 brake fluid if necessary.
22. Reposition the PCM and bracket (4) into mounting position (if equipped).
23. Install bolt (2) for the PCM mounting bracket to lower shock tower and tighten to 9 Nm (80 in. lbs.) (if equipped).
24. Install nut (1) for the PCM mounting bracket to upper shock tower stud and tighten to 9 Nm (80 in. lbs.) 9if equipped).
25. Connect battery negative cable See: Starting and Charging/Battery/Battery Cable/Service and Repair/Battery Cables - Installation.
26. Bleed the base brake system See: Brakes and Traction Control/Brake Bleeding/Service and Repair.
27. Bleed clutch system See: Service and Repair.
28. Actuate clutch pedal a minimum of fifteen times to allow any air ingested into the system to vent to the master cylinder reservoir.
29. Install the air cleaner cover (3) and the air intake hose (2) to the hose (1) leading down the back of the engine.
30. Road test the vehicle to ensure proper operation of the clutch and brakes.
