Patriot 2WD L4-2.4L (2009)
9. Remove the snap ring (1) from the terminal body (2).
10. Remove the nut holding the manual lever (1) to the manual shaft.
11. Remove the manual lever from the manual shaft.
12. To remove the control valve body assembly on to the transaxle case, fabricate a rod to set the pulley ratio linkage as shown. (1) 2 mm (0.08 in.)
Diameter, (2) 80 mm (3 in.) long, (3) 30 mm (1 in.) long, (4) 50 mm (2 in.) long.
