Patriot 2WD L4-2.4L (2009)
13. Install the rod into the linkage stopper hole (5) of the control valve assembly and secure under bolt head (3).
14. This sets the pulley ratio linkage (1) in position on the valve body (2).
CAUTION: Tilt the valve body assembly away from the transaxle case on the manual shaft side to ease removal. Pay attention to completely
remove the terminal body from the transaxle case.
NOTE: Mounting bolt ( 7) is shorter than bolts (1).
15. Remove the mounting bolts (1) and (7) of the control valve body assembly.
16. Remove the valve body assembly from the transaxle case.
Installation
