Patriot 2WD L4-2.4L (2009)
4. Install the spider assembly (2) to interconnecting shaft retaining snap ring (3) into groove on end of interconnecting shaft. Be sure the snap ring is
fully seated into groove on interconnecting shaft (1).
5. Distribute 1/2 the amount of grease provided in the seal boot service package (DO NOT USE ANY OTHER TYPE OF GREASE) into tripod
housing. Put the remaining amount into the sealing boot (3).
6. Align tripod housing (1) with spider assembly (2) and then slide tripod housing over spider assembly and interconnecting shaft.
7. Install inner tripod joint seal boot to interconnecting shaft clamp (3) evenly on sealing boot (4).
8. Clamp sealing boot onto interconnecting shaft using Clamp C-4975A and the following procedure. Place Clamp C-4975A over bridge of clamp.
