Patriot 4WD L4-2.4L (2009)
Leave the allen wrench installed during the remainder of this procedure.
11. Insert Locking Wedge 9701 (1) between camshaft phasers.
12. Lightly tap Locking Wedge 9701 (2) into place until it will no longer sink down.
NOTE: Camshaft bearing caps should have been marked during engine manufacturing. For example, number one exhaust camshaft bearing
is marked "E1>".
CAUTION: DO NOT use a number stamp or a punch to mark camshaft bearing caps. Damage to bearing caps could occur.
13. Using a permanent ink or paint marker, identify location and position on each camshaft bearing cap.
14. Remove the front camshaft bearing cap.
15. Slowly remove the remaining intake and exhaust camshaft bearing cap bolts one turn at a time.
