jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Removal and Replacement|Page 6016 > < Side Curtain Air Bag - Description|Page 6013
Page 1
background image

Air Bag: Removal and Replacement

Side Curtain Air Bag - Removal

REMOVAL

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before

attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper
precautions could result in accidental airbag deployment.

WARNING: To avoid serious or fatal injury when removing a deployed airbag, rubber gloves, eye protection, and a long-sleeved shirt should

be worn. There may be deposits on the airbag unit and other interior surfaces. In large doses, these deposits may cause irritation
to the skin and eyes.

WARNING: To avoid serious or fatal injury, use extreme care to prevent any foreign material from entering the side curtain airbag, or

becoming entrapped between the side curtain airbag cushion and the headliner. Failure to observe this warning could result in
occupant injuries upon airbag deployment.

NOTE: The following procedure is for replacement of an ineffective or damaged side curtain airbag. If the airbag is ineffective or damaged,

but not deployed, review the recommended procedures for handling non-deployed supplemental restraints. See: Service and Repair . If
the side curtain airbag has been deployed, review the recommended procedures for service after a supplemental restraint deployment
before removing the airbag from the vehicle. 
See: Service and Repair .

1. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
2. Remove the headliner from the vehicle. See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Headliner - Removal.
3. Disconnect the body wire harness connector (2) for the side curtain airbag from the connector receptacle at the back of the inflator (1) on the inner

roof side rail between the C and D-pillars.

Removal and Replacement|Page 6016 > < Side Curtain Air Bag - Description|Page 6013