Patriot 4WD L4-2.4L (2009)
10. Install the fasteners (1) securing the power steering hose routing clamps (2) to the crossmember. Use a NEW push clip on the left and tighten the
screw on the right to 8 Nm (71 in. lbs.).
11. Install the pressure hose (2) at the gear (3). Tighten the tube nut to 32 Nm (24 ft. lbs.).
12. Install the return hose (1) at the gear (3). Tighten the tube nut to 20 Nm (15 ft. lbs.).
13. Position the heat shield (3) and install the three screws (1, 2) securing the shield to the crossmember (4). Tighten the two front mounting screws
(1) to 4 Nm (35 in. lbs.). Tighten the rear mounting screw (2) to 17 Nm (150 in. lbs.).
14. Install the front engine mount through-bolt.
15. Install the rear engine mount. See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Engine Mount/Service and
Repair/Engine Mount Insulator - Installation.
