Patriot 4WD L4-2.4L (2009)
7. Install the two cushions (bushings) on the stabilizer bar utilizing the slit cut into the cushion sides.
8. Install the two stabilizer bushing retainers (3) over the cushions.
9. Install the screws (1) securing the stabilizer bushing retainers (3) to the crossmember. Tighten all four stabilizer bar cushion retainer screws to 30
Nm (22 ft. lbs.).
10. Attach the stabilizer bar link (1) at each end of the stabilizer bar (2). At each link, install and tighten the nut (3) while holding the stabilizer bar
link lower stud stationary. Tighten the nuts to 58 Nm (43 ft. lbs.).
11. Position the power steering hose routing clamps (2) on the crossmember. Install the fasteners. Tighten the screw to 8 Nm (71 in. lbs.).
12. Install the rear engine mount. See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Engine Mount/Service and
Repair/Engine Mount Insulator - Installation.