Patriot 4WD L4-2.4L (2009)
4. Install the bolt (2) securing the toe link to the trailing link. To install the bolt it may be necessary to flex the trailing link body mount bushing
inward or outward using an appropriate prying tool. Tighten the mounting bolt to 95 Nm (70 ft. lbs.).
5. Insert the parking brake cable through the trailing link from the inboard side.
6. Slide the parking brake cable (2) into the brake support plate (3) with parking brake shoes.
7. Install the hair pin (1) securing the parking brake cable (2) to the brake support plate (3).
8. Install the parking brake cable onto the lever on the parking brake shoe.
9. If equipped, position the wheel speed sensor (3) and install the screw (4) fastening the sensor to the trailing link (2). Tighten the mounting screw to
18 Nm (13 ft. lbs.).
10. If equipped, position the wheel speed sensor (3) and install the routing clip (1) fastening the sensor to the trailing link (2).
11. Install the hub and bearing, then install the brake rotor onto the wheel studs. See: Wheel Bearing/Service and Repair/Rear Hub and Bearing -
Installation
