Patriot 4WD L4-2.4L (2009)
5. Align axle shaft seal with axle shaft seal bore.
6. Install (case side) axle seal on Seal Installer 9934 and Handle C-4171 and insert into axle shaft seal bore.
7. Tap seal into position until seated against transaxle case.
8. Install axle shaft. See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Half Shaft - Installation
9. Check transaxle fluid level and adjust as necessary.
Input Shaft Seal - Removal
REMOVAL
1. Remove the transaxle See: Service and Repair/Removal and Replacement/T355 Manual Transmission - Removal.
2. Remove seal.
Input Shaft Seal - Installation
INSTALLATION
1. Install input shaft seal (2) using installer 8864 (1).
2. Install the transaxle See: Service and Repair/Removal and Replacement/T355 Manual Transmission - Installation.
Shift Shaft Seals - Removal
REMOVAL
It is not necessary to remove the shift shafts from the transaxle to service the shift shaft seals.
