Patriot 4WD L4-2.4L VIN W (2007)
Alarm Horn: Service and Repair
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the splash shield from the right front wheel house.
3. Locate the alarm siren module (1) on the outboard side of the right front fender load path beam (4).
4. Disconnect the engine compartment wire harness connector (5) from the connector receptacle near the back of the siren.
5. Remove the two screws (2) that secure the siren mounting bracket to the load path beam.
6. Remove the siren and mounting bracket from the load path beam as a unit.
