jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Component Tests and General Diagnostics|Page 8521 > < Garage Door Opener Transmitter|Description|Page 8518
Page 1
background image

Garage Door Opener Transmitter: Component Tests and General Diagnostics

UNIVERSAL TRANSMITTER

If the Universal Transmitter is inoperative, retrain the universal transmitter with a known good transmitter, insuring the transmitter battery is OK. Test
the universal transmitter operation again. If the unit is still inoperative, test the universal transmitter with Radio Frequency Detector special tool as
described below:

1. Turn the Radio Frequency (RF) Detector ON (3). A "chirp" will sound and the green power Light Emitting Diode (LED) will light (2). If the green

LED does not light, replace the battery (4).

2. Hold the RF detector within 2.5 cm (1 inch) of the TRAINED universal transmitter and press any of the transmitters buttons.

3. The red signal detection LEDs (1) will light and the tool will beep if a radio signal is detected. Repeat this test for all three transmitter buttons. If

the tool does not detect a radio signal for any of the three buttons, replace the inoperative universal transmitter assembly.

Component Tests and General Diagnostics|Page 8521 > < Garage Door Opener Transmitter|Description|Page 8518