Patriot 4WD L4-2.4L VIN W (2007)
5. Install the speed sensor cable routing clip (3) on the outside frame rail (4).
NOTE: When inserting the wheel speed sensor cable through the hole in the body, route the cable toward the shock tower to make it
easier to grasp the cable to connect it to the body wiring harness connector in a later step.
6. Insert the wheel speed sensor cable (5) through the hole in the body (1) and install the grommet (2) in the hole.
7. Install the tire and wheel assembly (1). Install and tighten the wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).
8. Lower the vehicle.
9. Through the opening in the bottom of the quarter trim panel, connect the wheel speed sensor cable connector (2) to the body wiring harness
connector (3).
