Patriot 4WD L4-2.4L VIN W (2007)
Compass: Removal and Replacement
Removal - Remote Compass Module
REMOVAL - REMOTE COMPASS MODULE
WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or
instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the
airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system.
Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury or death.
1. Disconnect and isolate the battery negative cable.
2. Using a trim stick C-4755 or equivalent, remove the upper trim cover over the center bezel and radio.
3. Remove the screws securing the Remote Compass Module (RCM) to the instrument panel.
4. Disconnect the RCM electrical connector and remove the RCM from the vehicle.
Installation - Remote Compass Module
INSTALLATION - REMOTE COMPASS MODULE
NOTE: The Remote Compass Module (RCM) must be calibrated after installation.
1. Position the Remote Compass Module on top of the instrument panel.
2. Install the screws that secure the RCM to the instrument panel.
3. Connect the RCM electrical connector.
