Patriot 4WD L4-2.4L VIN W (2007)
4.
Connect the CH9404 StarSCAN vehicle cable to the StarSCAN and the vehicle.
5.
Place the Ignition in the "RUN" position, then Power "ON" the StarSCAN.
6.
Select "ECU View".
7.
Select "TIPM/CGW".
8.
Select "MISC".
9.
Select "Restore Vehicle Configuration".
10.
Press "START"
11.
Press "Next".
12.
A selection box will appear on the StarSCAN screen. Scroll down and select "07 MK".
13.
Press "Next".
14.
When prompted, enter the full 17 digit VIN.
15.
Press "Next".
16.
Press "Next" again.
17.
Press "OK".
18.
When prompted, enter your User ID and Password.
19.
Press "OK".
20.
Press "Next" to configure the vehicle.
21.
Press "Next".
22.
Press "Finish".
23.
Wait one minute and turn the ignition key to the "OFF" position.
24.
Remove the StarSCAN unit, StarSCAN cable and charger from the vehicle.
25.
Install the inlet air duct.
26.
Check DRL for proper operation. Start the engine and fully release the park brake. Apply the service brakes and place the transmission
selector into "Drive" (D). The DRL should illuminate.
