Patriot 4WD L4-2.4L VIN W (2007)
18. Adjust the front camber to the preferred setting by pushing or pulling on the top of the tire. When camber is set to specifications, tighten the upper
and lower strut clevis-to-knuckle attaching bolt nuts (3, 4) enough to hold the adjustment. Again jounce the front and rear of the vehicle, then
verify the camber settings.
19. Tighten the front strut clevis-to-knuckle attaching bolt nuts (3, 4) to 84 Nm (62 ft. lbs.).
20. Once camber is within specifications, adjust toe to meet the preferred specification setting. Refer to FRONT TOE within this wheel alignment
service procedure.
TOE
1. Center the steering wheel and lock it in place using a steering wheel clamp.
NOTE: When setting toe, make sure to set rear toe to the preferred specifications before setting front toe to the preferred specifications
REAR TOE
NOTE: Perform the following at each rear wheel as necessary.
