jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Seat Belt Buckle|Removal|Page 8065 > < Seat Belt|Removal|Page 8060
Page 1
background image

Seat Belt Buckle: Service and Repair
Removal

Front

FRONT

WARNING:  To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.

1. Move the front seat to its most rearward position for easiest access to the front seat belt buckle (1) lower anchor.

2. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.

3. Remove the console from the floor panel transmission tunnel.

4. Remove the screw (2) that secures the front seat belt buckle lower anchor to the inboard side of the front seat cushion frame.

5. Remove the seat belt buckle from the front seat cushion frame.

Second Row - Center And Left

SECOND ROW - CENTER AND LEFT

WARNING:  To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.

Seat Belt Buckle|Removal|Page 8065 > < Seat Belt|Removal|Page 8060