Patriot 4WD L4-2.4L VIN W (2007)
Power Steering Pump: Service and Repair
Installation
GAS ENGINE
1. Using a lint free towel, wipe clean the open power steering pressure hose end and the power steering pump port. Replace any used O-rings with
new. Lubricate the O-ring with clean power steering fluid.
2. Place the pump in mounting position. Install the three bolts (1) through the pulley (3) openings. Tighten the mounting bolts (1) to 26 Nm (19 ft.
lbs.).
3. Install the drive belt (2).
4. Install the supply hose (1) at the pump (3).
5. Clamp the hose clamp (2) securing the supply hose (1) to the pump.
