Patriot 4WD L4-2.4L VIN W (2007)
1. Position the SCCM (3) over the steering column shaft (2).
2. Install the three screws (1).
3. Connect the electrical connectors (2) to the instrument panel harness, ensure wiring is properly routed. Then check that the connectors, locking
tabs are properly engaged.
4. Install steering column shrouds. Be sure all wires are inside of shrouds.
5. Install steering wheel ensuring the flats on hub align with the clockspring. Pull the airbag leads through the larger slot. Ensure leads do not get
pinched under the steering wheel.
NOTE: There is a small wire harness in the steering wheel and it contains the horn circuits and speed control circuits.
6. Connect the speed control and horn wire connector into the clockspring.
7. Pull the grenade pin out of the clockspring.
8. Install the driver airbag.
WARNING: Do not connect the battery negative cable. Personal injury or death may result if the system test is not performed first.
