Patriot 4WD L4-2.4L VIN W (2007)
Drive/Propeller Shaft: Service and Repair
Installation
INSTALLATION
CAUTION: Propeller shaft installation. Never allow propeller shaft to hang while connected to Power Transfer Unit (PTU), rear driveline
module flanges or center bearings. If propeller shaft section is hung unsupported, damage may occur to joint, boot and/or center bearing from
over-angulation. This may result in vibration/balance issues. A helper may be needed.
1. Make sure transaxle is in Neutral (N) position.
2. Obtain a helper if needed and lift propeller shaft assembly into position. Install propeller shaft spline into PTU.
3. Align marks (2) on propeller shaft with marks on rear axle flange. Slide propeller shaft over studs on rear axle flange.
4. Install the four retaining nuts (2).
