Patriot 4WD L4-2.4L VIN W (2007)
7. Clean all foreign matter from the threads of the half shaft outer C/V joint.
8. Install the washer (4) and hub nut (3) on the end of the half shaft and snug it.
9. While a helper applies the brakes to keep the hub (1) from rotating, tighten the hub nut (3) to 245 Nm (181 ft. lbs.).
10. Insert the cotter pin (2) through the notches in the nut and the hole in half shaft. If the notches in the nut do not line up with the hole in the half
shaft, continue to tighten the nut until they do. Do not loosen the nut.
11. Wrap the cotter pin (2) ends tightly around the lock nut.
12. Install the tire and wheel assembly (1). Install and tighten the wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).
13. Lower the vehicle.
14. Pump the brake pedal several times to ensure the vehicle has a firm brake pedal before moving it.
