Wagoneer L4-150 2.5L VIN H TBI (1986)
Transmission Governor (Exploded View)
1. Position the governor body-park gear assembly on the output shaft.
2. Align the governor valve shaft hole in the body with the hole in the output shaft and install the assembly.
3. Install the snap ring in the governor body (8).
4. Install the body-to-gear attaching bolts and tighten to 11 Nm (100 in. lbs.) torque.
5. Bend the ends of the lock tabs against the bolt heads.
6. Install the governor valve (10) on the valve shaft (9).
7. Insert the assembly into the body (8) and through the governor weights.
8. Install the retaining E-clip (1).
9. Install and tighten the adapter housing bolts to 32 Nm (24 ft. lbs.) torque.
10. Install the transfer case.
11. Install the rear crossmember.
