Wagoneer L6-242 4.0L VIN L FI (1989)
Fig. 5 Rocker Arm Assembly
5. Remove the capscrews, bridge and pivot assemblies and rocker arms Fig. 5. Alternately loosen each capscrew, one turn at a time, to avoid
damaging the bridge.
6. Remove the push rods Fig. 5. Retain the push rods, bridges, pivots and rocker arms in the same order as removed to facilitate installation in the
original locations.
7. Disconnect the power steering pump bracket. Set the pump and bracket aside. Do not disconnect the hoses.
8. Remove the intake and exhaust manifolds from the cylinder head. Refer to Engine/Intake Manifold/Service and Repair for the proper
procedures.
See: Intake Manifold/Service and Repair
9. If equipped with air conditioning, perform the following:
a. Remove the air conditioner compressor bracket bolts from the cylinder head.
b. Loosen the alternator drive belt and remove the alternator bracket-to-cylinder head mounting bolt. The serpentine drive belt tension is released
by loosening the alternator.
c. Remove the bolts from the A/C compressor mounting bracket and set the compressor aside.
10. Disconnect the ignition wires and remove the spark plugs.
11. Disconnect the temperature sending unit wire connector and battery negative cable.
12. Remove the ignition coil and bracket assembly.
