Wagoneer L6-242 4.0L VIN L FI (1989)
A.
Oxygen Sensor Inspection:
1.
Raise Vehicle on a hoist and locate oxygen sensor in exhaust manifold as shown in Figure 1.
^
If the oxygen sensor has a metal stone shield around the sensor body continue with Step B.
^
If the sensor does not have a stone shield, a new sensor has already been installed and no further service is required.
2.
Lower vehicle.
B.
Replace Oxygen Sensor:
WARNING:
Exhaust manifold becomes very hot during engine operation. Allow engine to cool before removing oxygen sensor.
1.
Disconnect the oxygen sensor electrical connector.
2.
Remove oxygen sensor using a crowfoot socket.
3.
Clean exhaust manifold threads.
4.
Install provided oxygen sensor (PN C3905610). Tighten to 22 ft.lbs. (30 N-m).
5.
Connect oxygen sensor connector.
6.
Lower vehicle.
Completion Reporting and Reimbursement
Claims for vehicles which have been serviced must be submitted on the DIAL System. Claims submitted will be used by Chrysler to record recall service
completions and provide dealer payments.
Use one of the labor operation numbers and time allowances (see illustration).
Add the cost of the recall parts package plus applicable dealer allowance to your claim.
