Wagoneer L6-242 4.0L VIN L FI (1989)
FIGURE 6
12.
Insert a paper clip into cavities 1 and 5 (Fig. 6) from the relay side, to release the locking tab of the terminals. Switch the wires in the cavity holes,
orange wire goes into cavity 1 and the yellow wire goes into cavity 5.
13.
Insert terminal K (Fig. 3), gray wire from kit, into the unused cavity (G - Fig. 6) of the O(2) relay holder. Install the white plastic retaining clip.
14.
Install the O(2) relay into the relay holder.
15.
Attach the O(2) relay assembly to the other three relay assemblies and install them to the fender bracket.
FIGURE 7
FIGURE 8
16.
Route the new harness down and along existing harnesses as shown in Figures 7 and 8. Secure the new harness to the existing harnesses using the
tie straps provided.
