Wagoneer L6-242 4.0L VIN L FI (1989)
Fig. 38 Disassembling upper end of steering column
5.
Remove lockplate, canceling cam, upper bearing preload spring and thrust washer from steering column/shaft.
6.
On 1991-92 models, ensure wiper switch is in OFF position.
7.
On all models, remove hazard warning switch knob by pressing knob inward and turning counterclockwise.
8.
Remove turn signal/wiper/cruise control stalk by pulling it straight out from column.
9.
Disconnect turn signal wire harness connector.
10.
Remove turn signal switch retaining screws and dimmer switch actuator arm, then remove switch.
11.
Remove wiper switch wire harness and all other wire harnesses located within steering column.
12.
Insert key into lock cylinder and turn to the On position.
13.
Remove key warning buzzer switch and contacts as a unit. Do not remove key warning buzzer and contacts separately, as contacts may
detach and drop into the steering column.
14.
With lock cylinder in On position, remove retaining screw and pull lock cylinder out of steering column.
Fig. 39 Removing ignition & dimmer switches
15.
Remove ignition switch and dimmer switch from lower end of steering column.
Fig. 34 Key cylinder housing assembly
