Wagoneer L6-242 4.0L VIN M FI (1988)
clamp around the exhaust pipe (Figure 7).
38.
Using the provided seal, connect the exhaust downpipe to the exhaust manifold. Torque the bolts to 23 ft.lbs. (31 N-m).
39.
Tighten the bell housing exhaust bracket bolt and clamp.
40.
Install the provided oxygen sensor. Torque the sensor to 35 ft.lbs. (48 N-m).
41.
Connect the oxygen sensor connector.
42.
Lower the vehicle.
43.
Connect the battery negative cable.
44.
Install the Recall Completion Label:
a.
With a ball point pen, print your dealer code (5 digits) on the supplied Recall Completion Label.
b.
Peel the label from its backing and apply it near the Vehicle Emission Control Information Label located on the bulkhead.
45.
Complete and provide the owner with a Vehicle Emission Recall Proof of Correction form. Blank forms have been provided.
Completion Reporting and Reimbursement
Claims for vehicles which have been serviced must be submitted on the DIAL System. Claims submitted will be used by Chrysler to record recall service
completions and provide dealer payments.
Use one of the labor operation numbers and time allowances.
Add the cost of recall parts plus applicable dealer allowance to your claim.
Note:
See Warranty Policy and Procedure Manual, Chapter 6, Subsection H for complete recall claim processing instructions.
Parts Return and Vehicle Not Available
Parts Return
Not required.
Vehicle Not Available
If a vehicle is not available for service for a known reason, let us know by filling out the pre-addressed Vehicle Disposition Form portion of the Owner
Recall Notification Form or describe the reason on a postcard and mail to:
Chrysler Corporation 415-03-18
Recall Coordination
P.O. Box 1919
Detroit, Michigan 48231-9986
Following the above procedures will expedite the processing of your claim.
If you have any questions or need assistance in completing this action, please contact your Zone Service Office.
Owner Letter
