Wagoneer L6-242 4.0L VIN M FI (1988)
FIGURE 2
15.
Secure the CPS lead to the retaining clip (G) on the bellhousing. (Figure 2)
16.
Route the new CPS lead up the back of the engine.
17.
Lower the vehicle.
18.
Secure the CPS lead in the retaining clip (F) which is located at the left rear corner of the cylinder head. Allow 5 inches of the CPS lead to extend
past the clip. (Figure 2)
FIGURE 5
19.
From inside the vehicle locate the ECU (K) which is mounted vertically under the instrument panel to the right of the steering column (L). (Figure
5)
