Wagoneer L6-242 4.0L VIN M FI (1988)
FIGURE 6
23.
Lightly oil inside lip of new seal.
24.
Install new seal (16) onto preliminary installer 6228-1. Be sure that the seal lip has not pulled up onto the edge of the installer.
FIGURE 7
25.
Slide adapter J-34659-4 and gauging sleeve 6228-2 over rod J-34659-3. Position assembly in axle tube.
26.
Through vacuum motor access hole, thread preliminary installer 6228-1 onto end of rod J-34659-3 with seal facing steering knuckle.
NOTE:
PRELIMINARY INSTALLER 6228-1 ONLY INSTALLS THE SEAL HALFWAY. PRELIMINARY INSTALLER 6228-1
MUST BE SCREWED TIGHTLY ONTO ROD J- 34659-3 FOR CORRECT SEAL INSTALLATION.
27.
With open-end wrench, hold rod J-34659-3 in place and tighten nut (13) until it stops.
28.
Loosen nut.
FIGURE 8
29.
Insert a drift punch into hole (17) in edge of preliminary installer 6228-1. Hold punch and unscrew rod J-34659-3. Leave gauging sleeve 6228-2