Wagoneer L6-258 4.2L VIN C 2-bbl (1982)
Ignition Switch: Service and Repair
The ignition switch is mounted on the lower portion of the steering column and is connected to the steering lock by a remote control actuator rod.
REMOVAL
1.
Disconnect battery ground cable.
2.
Place ignition in "OFF-UNLOCK" position and remove switch attaching screws.
3.
Disconnect switch from control rod and electrical connector from switch, then remove switch from steering column.
INSTALLATION
1.
Move switch slider to "ACCESSORY" position.
2.
Engage remote actuator rod into switch slider and position ignition switch onto steering column. Do not move switch slider when positioning
ignition switch onto steering column jacket.
3.
Install and torque switch retaining screws to 35 inch lbs.
4.
Connect electrical connector onto switch.
5.
Connect battery ground cable and check ignition switch for proper operation.
