Wrangler L4-150 2.5L VIN E TBI (1990)
Seat Belt: Service and Repair
Seat Belt Removal/Installation
1. Remove the seat belt anchor bolt.
2. Remove the seat belt.
3. Remove the shoulder belt trim cover, anchor bolt and washers.
4. Remove the door sill trim cover for access to the retractor anchor bolts.
5. Remove the anchor bolts attaching the lower part of the shoulder belt to the floorpan and body side.
6. Remove the belts.
7. Inspect the seat belt material for evidence of wear, cuts or fraying. Replace any belt if worn or damaged.
8. Install the seat belt and shoulder belt anchor bolts. Tighten to 34-47 Nm (25-35 ft lbs) torque.
9. Position the shoulder belt guide on the B-pillar or sport bar and install the bolt.
10. Install the belt trim covers.
11. Install the door sill trim cover.