Wrangler L4-150 2.5L VIN E TBI (1990)
Ignition Switch Lock Cylinder: Service and Repair
1.
Disconnect battery ground cable.
2.
Apply tape to painted areas of steering column.
3.
Remove steering wheel refer to Steering and Suspension/Steering/Steering Wheel/Service and Repair.
4.
Using a suitable tool, remove lock plate cover from steering column.
5.
Compress lock plate and remove steering shaft snap ring as follows:
Metric Steering Shaft Identification
a.
Check and identify steering shaft nut thread type. Metric type steering shafts have an identifying groove in the steering wheel locating splines.
Compressing Lock Plate & Removing Snap Ring
b.
If steering shaft is not a metric type, use lock plate compressor tool No. J-23653 to compress lock plate and remove snap ring.
c.
If the steering shaft is of the metric type, replace compressor tool bolt with metric forcing bolt J-23653-A before installing compressor tool
onto steering shaft. The lock plate is under strong spring tension. Do not attempt to remove the steering shaft snap ring without using the
specified lock plate compressor tool.
6.
Remove compressor tool and snap ring.
7.
Remove lock plate, canceling cam, and upper bearing preload spring.
8.
Remove turn signal lever.
9.
Remove hazard warning knob from steering column.
10.
Remove turn signal switch attaching screws and position switch aside.
11.
Position lock cylinder in On position.
12.
Remove key warning switch switch and retaining clip with needle nose pliers or other suitable tool. Do not attempt to remove switch and clip
separately, as clip could may drop into steering column jacket.
