Wrangler L4-150 2.5L VIN P MFI (1993)
8. Place a transmission jack, under the center of the fuel tank.
9.
Remove the seven mounting nuts connecting the skid plate to the crossmember and lower the tank far enough to allow the wiring connector and
fuel lines to be disconnected from the fuel tank sending unit (Figure 2).
10.
Lower the tank and remove from under the vehicle.
B. Remove and Straighten Fuel Tank Sending Unit
1.
Clean dirt from around fuel tank sending unit flange.
2.
Remove the eight fuel tank sending unit retaining screws. Remove sending unit and discard old gasket. Be careful not to bend float arm.
3.
Without the gasket installed, straighten the sending unit flange by installing the sending unit in the fuel tank with the provided ring on top of the
flange as shown in Figure 3.
