Wrangler L4-150 2.5L VIN P MFI (1993)
e.
To release fuel pressure, screw the other end of the hose onto the fuel pressure test port.
f.
After fuel pressure has been released, remove the hose from the test port.
g.
Install protective cap on pressure test port. Remove shop towels and dispose of properly.
4.
Using a portable gasoline siphon/storage tank, drain fuel tank.
5.
Raise vehicle on hoist.
6.
Using a small straight blade screwdriver, pull back the stem of the push clips that secure the fuel filler neck shroud at the bottom of the left rear
wheel well and remove shroud (Figure 1).
7.
Disconnect vent hose and filler hose from fuel tank.
WARNING:
WRAP SHOP TOWELS AROUND FUEL HOSES TO ABSORB ANY FUEL SPILLAGE DURING FUEL TANK REMOVAL.
8.
Place a transmission jack, under the center of the fuel tank.
9.
Remove the seven mounting nuts connecting the skid plate to the crossmember and lower the tank far enough to allow the wiring connector and
fuel lines to be disconnected from the fuel tank sending unit (Figure 2).
10.
Lower the tank and remove from under the vehicle.
B. Remove and Straighten Fuel Tank Sending Unit
