Wrangler L4-150 2.5L VIN P MFI (1993)
1.
Remove the four screws that attach the A/C unit to the instrument panel (IP) (Figure 1).
2.
Lower the A/C unit to gain access to the black A/C wiring connector located on the right side of the steering column.
3.
Disconnect the black wiring connector (Figure 2) and install the supplied jumper harness between the two halves of the connector.
4.
Raise the A/C unit into place and install the four screws that attach the A/C unit to the IP. Verify the operation of the A/C blower.
5.
Start the engine and verify that the yellow ABS light goes out after the initial bulb check cycle. If the light does not go out, diagnose and
repair following normal service procedures.
B.
Install Jumper Harness (Vehicles Not Equipped With Air Conditioning):
