Wrangler L4-150 2.5L VIN P MFI (1993)
12.
FOR 1991 - 1992 MY VEHICLES:
Remove the green wire from cavity G5 and install it in cavity A6 (Figure 2).
FOR 1993 MY VEHICLES:
Remove the yellow wire from cavity G5 and install it in cavity A6. Remove the existing white/tan wire from cavity A6 and install it in cavity G5
(Figure 2).
13.
Reinstall the blue wedge.
14.
Reunite the two sections of the bulkhead connector.
15.
Reattach the fuse block to the bulkhead connector.
16.
Install the fuse block/instrument panel bulkhead connector with the two attaching screws.
17.
Reconnect the engine compartment bulkhead connector.
18.
Connect the battery negative cable.
Completion Reporting and Reimbursement
Claims for vehicles which have been serviced must be submitted on the DIAL System. Claims submitted will be used by Chrysler to record recall service
completions and provide dealer payments.
Use one of the following labor operation numbers and time allowances:
NOTE:
To ensure proper payment, be sure to use the correct labor operation number for the applicable recall as shown. The recall number can also be identified
from the Owner Notification Form (lower right), from the applicable dealer vehicle list or from DIAL System Function 70.
Note:
See Warranty Policy and Procedure Manual, Chapter 6, Subsection H for complete recall claim processing instructions.
Parts Return
