Wrangler L4-150 2.5L VIN P MFI (1993)
Service Procedure
1.
With the ignition key in the OFF position, disconnect the negative battery cable.
2.
Disconnect the engine compartment bulkhead connector.
3.
Separate the larger section of the bulkhead wiring connector from the connector.
4.
Remove the blue wedge.
5.
FOR 1991 - 1992 MY VEHICLES:
Remove the green wire from cavity G5 and install it in cavity A6 (Figure 1).
FOR 1993 MY VEHICLES WITHOUT
ABS: Remove the yellow wire from cavity G5 and install it in cavity A6 (Figure 1).
FOR 1993 MY VEHICLES WITH
ABS: Remove the yellow wire from cavity G5 and install it in cavity A6. Remove the existing white/tan wire from cavity A6 and install it in cavity
G5 (Figure 1).
6.
Reinstall the blue wedge.
7.
Reunite the two sections of the bulkhead connector.
8.
Remove the two fuse block/instrument panel bulkhead connector attaching screws.
9.
Separate the fuse block from the bulkhead connector.
10.
Separate the larger section of the bulkhead wiring connector from the connector.
11.
Remove the blue wedge.
