Wrangler L4-150 2.5L VIN P MFI (1993)
27.
Insert hazard warning knob in switch and press inward. Install turn signal switch retaining screws. Ensure switch is properly seated before
tightening screws. Torque attaching screws to 33 inch lbs. Thread hazard warning switch knob into switch and pull knob outward.
28.
Install and seat upper bearing race in lock cylinder housing.
29.
Install upper bearing preload spring, canceling cam and lockplate.
30.
Install new lockplate retaining snap ring on sleeve of compressor tool, then tool on steering shaft.
31.
Compress lockplate with compressor tool and position snap ring in steering shaft groove.
32.
Remove compressor tool. Ensure snap ring is completely seated in groove before removing tool.
33.
Install lockplate cover, then steering wheel.
34.
Insert ignition key in lock cylinder. Turn cylinder to Off position, then move ignition switch downward to eliminate any switch-to-rod lash.
Torque switch attaching screws to 35 inch lbs.
35.
Depress dimmer switch slightly and insert a 3/32 inch drill bit into adjustment hole.
36.
Loosen retaining screws and move dimmer switch toward steering wheel to remove any lash from actuator rod. Torque dimmer switch retaining
screws to 35 inch lbs.
37.
Remove drill bit. Test dimmer switch operation in full-up, down and center steering wheel positions.
38.
Install steering column in vehicle if necessary.
