Wrangler L4-2.4L VIN 1 (2006)
Acceleration/Deceleration Sensor: Service and Repair
G-SWITCH
REMOVAL
1. From the drivers side lift carpet back in front of the console/shifter.
2. Disconnect harness for switch.
3. Remove mounting bolts and remove switch.
INSTALLATION
CAUTION: The mercury switch (inside the G-switch), will not function properly if the switch is installed incorrectly. Verify that the switch locating
arrow is pointing to the front of the vehicle.
1. Position switch on mounting bracket.
2. Install mounting bolts and tighten to 4 - 5 Nm (35 - 45 in. lbs.)
3. Connect harness to switch.
4. Place carpet back into position.
