Wrangler L4-2.5L VIN P (1999)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position Sensor - Auto Trans.
Crankshaft Position Sensor - Manual Transmission (Typical)
The crankshaft position sensor is mounted to the transmission bellhousing at the left/rear side of the engine block.
The sensor is attached with two bolts. On this engine with automatic transmissions, the sensor is attached with two nuts.
REMOVAL
1. Near rear of intake manifold, disconnect pigtail harness (electrical connector) from main electrical harness.
2. Depending upon application, remove either sensor mounting bolt(s) or nuts.
3. Remove sensor from engine.
INSTALLATION
With manual transmission:
1. Install sensor flush against opening in transmission housing.
2. Install and tighten two sensor mounting bolts to 19 Nm (14 ft. lbs.) torque. The two sensor mounting bolts are specially machined to correctly
space unit to flywheel. Do not attempt to install any other bolts.
With automatic transmission:
