Wrangler L4-2.5L VIN P (1999)
3. Install and tighten two sensor mounting nuts to 19 Nm (14 ft. lbs.) torque.
4. New Sensors: Be sure paper spacer is installed to bottom of sensor. If not, obtain spacer
5. Used Sensors: Clean bottom of sensor and install spacer PN05252229.
6. Install sensor into transmission bellhousing hole.
7. Push sensor against flywheel/drive plate. With sensor pushed against flywheel/drive plate, tighten mounting bolt to 7 Nm (60 in. lbs.) torque.
8. Connect sensor pigtail harness electrical connector to main wiring harness.
