Wrangler L4-2.5L VIN P (1999)
Wiper Switch: Service and Repair
Front Wiper & Washer Switch
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIRBAG AND SEAT BELTS/AIR BAGS BEFORE ATTEMPTING
ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO
TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIR-BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the knee blocker from the instrument panel. See Knee Blocker in Instrument Panel Systems for the procedures.
Steering Column Shrouds Remove/Install
3. Remove the three screws that secure the lower steering column shroud to the upper shroud.
4. If the vehicle is equipped with a standard non-tilt steering column, loosen the two upper steering column mounting nuts. If the vehicle is equipped
with the optional tilt steering column, move the tilt steering column to the fully lowered position.
5. Remove both the upper and lower shrouds from the steering column.
Water Shield Upper Screws Remove/Install
6. Remove the two screws that secure the switch water shield and bracket to the top of the steering column.
