Wrangler L6-242 4.0L VIN S MFI (1991)
pintle more than .250 in. If the pintle is extended further than .250 in, it may separate from the idle speed stepper motor. If the pintle separates
from the motor, it is necessary that the whole part be replaced.
8.
With the ignition switch OFF, switch the exerciser tool between HIGH and LOW, and observe the movement of the pintle.
^
If the idle speed stepper motor pintle does not move, replace and retest as described in step 6.
^
If the pintle operates properly, check the idle speed stepper motor bore in the throttle body for corrosion or blockage and clean as
necessary. Reinstall the stepper motor and retest. If no blockage is found, see manufacturers instructions for exerciser tool.
