Wrangler L6-242 4.0L VIN S MFI (1991)
NOTE:
A small gap may remain between the sending unit flange and the fuel tank (Figure 4). Press down firmly on one side of the flange to start the
first screw. Then work around the flange until all screws are installed. DO NOT INSTALL THE NEW LONGER SCREWS AS DAMAGE
TO THE TANK MAY OCCUR.
3.
Using the original retaining screws and an inch pound torque wrench, torque sending unit flange ring to 65 in-lbs. in the sequence shown in Figure
5.
IMPORTANT:
TO AVOID DAMAGE TO THE NEW GASKET AND TO MAKE SURE THE SENDING UNIT FLANGE IS COMPLETELY
STRAIGHTENED, DO NOT INSTALL THE NEW GASKET.
4.
Remove and discard the eight original sending unit retaining screws and remove the sending unit. Be careful not to bend float arm.
C. Install Fuel Tank Sending Unit Gasket
