Wrangler L6-4.0L VIN S (2000)
Glove Compartment: Removal and Replacement
Glove Box
WARNING: ON VEHICLES EQUIPPED WITH AIR-BAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE.
FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIR-BAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Release the glove box latch and open the glove box door.
Glove Box Remove/Install
3. While supporting the glove box door with one hand, grasp the check strap as close to the glove box door as possible and slide the rolled end of the
check strap out of the slot in the edge of the door.
4. Lower the glove box door far enough to disengage the hinge hook formations on the lower edge of the door from the hinge pins on the lower edge
of the instrument panel.
5. Remove the glove box from the instrument panel.
INSTALLATION
1. Position the glove box to the instrument panel.
2. Engage the hinge hook formations on the lower edge of the glove box door with the hinge pins on the lower edge of the instrument panel.
3. Tilt the upper edge of the glove box door up toward the instrument panel far enough to engage the check strap with the door.
4. While supporting the glove box door with one hand, grasp the check strap as close to the glove box door as possible and slide the rolled end of the
check strap into the slot in the edge of the door.
5. Close the glove box door.
6. Reconnect the battery negative cable.
Glove Box Latch Striker Replacement
WARNING: ON VEHICLES EQUIPPED WITH AIR-BAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE
FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the glove box from the instrument panel.
