Wrangler L6-4.0L VIN S (2000)
Caliper Installation
2. Install caliper by position notches at lower end of brake shoes on bottom mounting ledge. Then rotate caliper over rotor and seat notches at upper
end of shoes on top mounting ledge.
3. Coat caliper mounting bolts with silicone grease. Then install and tighten bolts to 15 Nm (11 ft. lbs.).
Mounting Bolt Dimensions
CAUTION: If new caliper bolts are being installed, or if the original reason for repair was a drag/pull condition, check caliper bolt length before
proceeding. Bolts must not have a shank length greater than 67.6 mm (2.66 in.).
4. Install brake hose to caliper with new seal washers and tighten fitting bolt to 31 Nm (23 ft. lbs.).
CAUTION: Verify brake hose is not twisted or kinked before tightening fitting bolt.
5. Bleed base brake system.
6. Install wheel and tire assemblies.
7. Remove supports and lower vehicle.
8. Verify firm pedal before moving vehicle.