Wrangler L6-4.0L VIN S (2000)
Drive Belt: Service and Repair
Correct drive belt tension is required to ensure optimum performance of the belt driven engine accessories. There are different types of adjustment
gauges for checking either a serpentine or a V-type belt. Refer to the instructions supplied with the gauge. Use the correct gauge when checking belt
tension. Place gauge in the middle of the section of belt being tested (between two pulleys) to check tension. Do not allow the gauge (or gauge
adapter) to contact anything but the belt.
BELT SCHEMATICS
The belt routing schematics are published from the latest information available at the time of publication. Vehicles not equipped with Power Steering
have an idler pulley in place of the power steering pump pulley. If anything differs between these schematics and the Belt Routing Labell, use the
schematics on Belt Routing Label. This label is located in the engine compartment.
Fig. 38
