Wrangler L6-4.0L VIN S (2000)
Vacuum Actuator Remove/Install - Typical
3. Insert a trim stick or another suitable wide flat-bladed tool into the latch hole on the Heater-A/C housing actuator mount. Gently pry the actuator
latch while pulling firmly outwards on the actuator to remove the actuator from the mount.
4. Rotate and tilt the vacuum actuator as required to disengage the hole on the end of the actuator link from the hooked pin on the end of the
panel/demist door lever.
5. Remove the panel/demist door vacuum actuator from the vehicle.
INSTALLATION
1. Reverse the removal procedures to install.